Faults and solutions of intravenous infusion in dogs

Faults and solutions of intravenous infusion in dogs

Faults and solutions of intravenous infusion in dogs
If you find that the infusion is not dripped, you can move the position of the foot inject that foot

Many owners' dogs have the energy of infusion, and they often encounter some problems in the process of infusion. Generally, we will find a doctor to solve it, but if the doctor is too busy, we should still master the corresponding solution ourselves.

1. The solution does not drop

1. Except for the needle to slide the blood vessels: If this is the case, it is because the liquid is injected with the subcutaneous tissue. At this time, the dog's needle will have a swelling and pain. At this time, you should select another blood vessels and then separate the needle.

2. The needle oblique surface is tightly attached to the blood vessel wall: the liquid drips is blocked. You can adjust the position of the needle or change the position of the limb properly.

3. Excessive pressure: The infusion pipe of the lower section of the folding pinch tube.

4. Too low pressure: Due to the poor circulation of the dog or the position of the infusion bottle too low, the position of the infusion bottle can be increased.

5. Varicose spasm: Apply the upper end of the injection with a hot water bottle or hot towel to relieve vein spasm.

2. Demonive liquid leakage when intravenous injection

1. Immediately use the syringe to extract the leakage liquid.

2. Such as such as equal osmotic solutions (such as physiological saline or equivalent glucose), generally absorb naturally naturally.

3. If a high -lytic solution is a high -lying salt solution, an appropriate amount of sterilization injection water should be injected into the swelling part and the surrounding area to dilute.

4. If the liquid that is highly irritating or corrosive, physiological saline should be injected into the surrounding tissue, such as calcium chloride, which can inject 10%ammonium sulfate or 10%sodium sulfate 10-20ml , Turn calcium chloride into non -irritating calcium sulfate and sodium chloride.

5. Topen can be used for warm compresses with 5%-10%magnesium sulfate to relieve pain.

6. If a large amount of medicinal liquid leaks, early cuts should be made, and a high -lying magnesium sulfate solution should be drained.

Dogs mainly pay attention to the feed when infusion, try to make the drop of the solution slower as possible, and the fast drop speed has a certain burden on the dog's body, especially for the sick dog. In addition, low -temperature dogs need to use heater, which reminds doctors. However, when dogs are injected with globulin and albumin, the solution heater should be removed, otherwise the drug will degenerate and lose its effect.